A solar photovoltaic panel enables you to charge any sort of electrical accumulator. A lithium-ion (Li-ion) battery would be the type utilised in many cameras, mobile devices, notebooks, and other portable devices. Li-ion batteries are understanding of overcharging and require sophisticated electronics within the charging device to be sure the batteries are charged correctly. Making it charger itself is not advised, but connecting a Li-ion charger into a screen is actually comparatively easy. Employ a question? Get an answer from Online Tech Support now! HP EliteBook 2560p Notebook PC Battery
People Are Reading
Steps to make a free of charge Solar Panel Charger From Scrap
Learning to make a Solar Accumulator
Things You will require
Li-ion re-loader
Cigarette plug adaptor
Copper wire
Instructions
1
Go to a store that sells cameras and computers, or use the web. You will discover many chargers available for the Li-ion battery you would like to charge. Buy a charger that features a car cigarette lighter connector, and this can are powered by an immediate-current (DC) voltage as high as 24 volts. Dell Precision M6600 Battery
2
Browse the specifications for the charger. Note the utmost charging current in amps. For the notebook computer re-loader, the charging current may be five or six amps. For camera and cell phone batteries the present in most cases be below 1 amp.
3
Look into the output of the solar array. Seek out the ideal power current (Imp) in amps, along with the maximum power voltage (Vmp) in volts produced by the panel. Make sure the ideal power current that is generated by the panel comes to, or more than, the ideal charging current necessary for the wall charger. Be sure the absolute maximum power voltage is between 12 and 24 volts. Asus A42-M70 Battery
4
Buy an adapter which will connect the solar array towards the cigar lighter plug. These adapters have two alligator clips at one end (red and black) and a female type lighter connector with the opposite end.
5
Install the screen inside a place where no shadows cross the panel daily. Orient the panel south and inclined at an angle adequate to the latitude of your respective location. Connect copper wire towards bad and good terminals with the panel, and run the wires to the alligator clips from the charger adapter. Connect the positive wire towards the red clip, and the negative wire towards the black clip. Connect the Li-ion wall charger and check that it really is working.
RSS Feed